Pinning test prop question

sharkey · Sep 21, 2009

I've only done test cycles that require once a week injections (test e and sustanon, have not tried test cyp.) From what I've read about test p. I would definitely like to try it for my next cycle. I'm just weary about ED or even EOD injections. Can you pin test p with an insulin needle? I can see how that would be much easier to do than the longer thicker needles. Any suggestions, comments, personal experiences much appreciated.

xcelbeyond · Sep 21, 2009

This needs to be injected deep IM - so an insulin pin will not work. Go with a 25g, 1" long needle - that's that I use for most all sites. Just make sure you rotate injection sites - I use thighs, glutes, delts and biceps. You can leave out the biceps if you don't feel comfortable doing these.

EasyEJL · Sep 21, 2009

if you buy the endosyn ethyl oleate based prop, you can manage slin pin injections. Otherwise the oil is just too thick to pass thru a 29ga reasonably. still have to be careful as to site, can't use gluts or even quads, would have to rotate bis/tris/delts/pecs i'd guess

sharkey · Sep 22, 2009

xcelbeyond said:
This needs to be injected deep IM - so an insulin pin will not work. Go with a 25g, 1" long needle - that's that I use for most all sites. Just make sure you rotate injection sites - I use thighs, glutes, delts and biceps. You can leave out the biceps if you don't feel comfortable doing these.

Thanks!

maldorf · Sep 22, 2009

If using 29 gauge needle with the EO base you still need to be sure the needle is 1 inch or longer to get deep IM. That setup works well with syntherol.

FeverishFlux · Sep 22, 2009

Mal he can push a 1/2 or 5/8ths hard to make up for the shorter pin, I don't know of anyone who makes a pin over 25g that's 1". I'd luv someone to make a 27g at 1" and 1.5".
You're going to have to really heat up the oil to push that prop thru the small pins bro. It's going to be irritating at first, but once the oil cools you'll be fine if it's good gear. It takes a long time to push cold oils thru small pins, so heat that stuff up, you aren't going to hurt the gear.:st:r-wars