So right now I'm using injectable vitamin b12; and something similar to synthelesen; how come when I try to use the 3cc needles shit keeps leaking out; like the fluid keeps leaking out when I inject mid way.
I'm no brain surgeon but perhaps the contents of the syringe are larger than the diameter of the needle and create pressure past the point in which the articulation of the syringe and needle can withstand.
Try heating your solution, using a larger needle or different brand of syringe.
I'm no brain surgeon but perhaps the contents of the syringe are larger than the diameter of the needle and create pressure past the point in which the articulation of the syringe and needle can withstand.
Try heating your solution, using a larger needle or different brand of syringe.
It's basically a 1 inch 3cc insulin like syringe; I filled up the needle to inject in my quad; then half way when I'm pushing it in shit is fucking leaking out of the syringe.
Insulin needles usually just press into a syringe and do not screw into the syringe. If there is too much pressure in the contents of the syringe it has to give somewhere and it could push the needle off allowing for a leak.
The contents of the solution are probably too big to go through a small insulin needle. Use a larger needle and heat your solution to dissolve the solids a little more. This may help.
Insulin needles usually just press into a syringe and do not screw into the syringe. If there is too much pressure in the contents of the syringe it has to give somewhere and it could push the needle off allowing for a leak.
The contents of the solution are probably too big to go through a small insulin needle. Use a larger needle and heat your solution to dissolve the solids a little more. This may help.
I'm no brain surgeon but perhaps the contents of the syringe are larger than the diameter of the needle and create pressure past the point in which the articulation of the syringe and needle can withstand.
Try heating your solution, using a larger needle or different brand of syringe.
I figured it out; I tighten the hub before and then shoot out air before drawing and then injecting; that seems to be the solution. Guess this is the way to properly use 3cc; I'm only used to using the insulin 29ga 1cc syringe never the 3cc syringes.
I guess so; that and pushing air out also; cause I remember when using it; it took a while for it to draw up the liquid on top; I realize I have to do this with every needle.