Test issue****

[Othus]

Ok, i bought 10 bottles test e 350; i gave 2 to a friend and the issue we both had is the pain is so bad from injection we had to stop.
I injected1 cc in 4 different area and all were painfullz,swollen and beat red and took 5-6 days to recover.
My question is there anything ican do to see if its overdosed, bad or is it just to strong for a full cc.
I have been pinning test for 3 years all from same sponsor so im confused and no i will not name the sponser

 

[SOUR DIESEL]

Ok, i bought 10 bottles test e 350; i gave 2 to a friend and the issue we both had is the pain is so bad from injection we had to stop.
I injected1 cc in 4 different area and all were painfullz,swollen and beat red and took 5-6 days to recover.
My question is there anything ican do to see if its overdosed, bad or is it just to strong for a full cc.
I have been pinning test for 3 years all from same sponsor so im confused and no i will not name the sponser

^^^very sorry to hear about your dilemma, BUT GOOD NEWS we'r all very fortunate that there is HPLC testing available today

..send a PM to "buck1973" or "Racepicks" ..they will tell you how to proceed

in addition there is existing test results for many sponsors posted @AnaSci
(..and some here as well, but i believe they are for GH)

best of luck

 

[Crazy_jay]

Higher concentrated doses require either more ba or bb to hold and not crash. Cant remember which one as I dont brew but which ever one it is also causes pip. That's why you dont see a lot high dosed gear. Try pinning less amount mixed with something else to dilute it.

Sent from my SM-G965U using Tapatalk

 

[Othus]

I was curious about that, thought maybe 1/2 cc with deca or tren

 

[ill gotten gains]

You said you have been using test from the same sponsor for 3 years but we’re they all dosed at 350 mg per cc?

 

[Othus]

No, test c range from 250 thru 400 which i believe was a mix of e and c
This is first test E at that range i used

 

[Geardepot]

Hey bro...here are a few tips you could try to lessen the PIP:
1. Heat the oil. Whether you choose to warm the oil once it's in the syringe barrel under hot water for a few minutes, or in a heating pad (my preference) or warm the whole vial is up to you. Increasing the temperature to around body temp really makes a huge difference.
2. Use the shortest needle possible, while still performing an intramuscular injection (avoid the subcutaneous layer, it will hurt). For example, if you are lean you can use a 5/8" needle in you delts, no need for a 1" or 1.5" in my experience.
3. Roll out/massage the area post injection. About 5 minutes after you inject, start giving it a good massage. Move the oil around as much as you can. Ideally, you can put a heating pad on the area 5 minutes before you start rolling/massaging, as that seemed to help soften it all up.
GD

 

[bad rad]

I always had to dilute high concentration gear with sterile oil. The body absorbs the oil faster than the high concentration of Test and leaves Test crystals behind. Think Test Suspension issues. The required high BA doesn't help either.