any home remedies to help aid with post injection pain, just hopped on some test E from a sponsor and I have the worst knot in my ass !
Pip from test e? Is it highly concentrated? Also yes a heating pad does well with either massaging the area or possibly the roller
Whenever I see posts about injection pain, I expect to see test enanthate as the culprit. 9 out of 10 times I'm right.What's up with a lot of the Test E raws from china and them causing PIP? I have heard this from a couple of different sources.
Also for the pain, stay away from ice and use heat/massage the area.
Pip has a lot to do with solvents. Maybe too much bb or ba.
Also injecting too fast or a Shakey hand can cause it too.
Sent from my iPhone using Tapatalk
Make sure u inject deep and slow. If u keep getting pip its most likely the gear. I had a painful batch my first cycle. No matter what i did I got terrible pip after every injection.
Whenever I see posts about injection pain, I expect to see test enanthate as the culprit. 9 out of 10 times I'm right.
Personally experienced this and confirmed it was the TE raws that were the cause. I remember janoshik state that he tested some retained test e and it showed multiple decomposition products. Some breakdown product in it must be irritating as shit.
Sent from my SM-N920P using Tapatalk
you should be able to go 2+inches with a 1in pin in the glute....
Shot in the ass for the 1st time in years, also my first cycle back in years and I had a ton of left over 23g 1in pins , so I have a feeling I also was nowhere deep enough, with these I may stick with shoulders, maybe quad.. any thoughts of 1" is enough for quads?
Sponsor says it's 300mg/ml and it's from the highest quality Raws so dosage should be every bit of that 300
you PIP issue is not from the most likely not from the raws. That would mean there is something seriously wrong with the raw powder, which I doubt from Test e. It`s a very easy blame for a source, but in reality, it is how it was compounded! Higher concentrations of things will need more or different solvents, some these can cause lumps at higher levels. Another hole in the cycle of compounding, the vials were not sterilized before putting finished product in. Many things can go wrong making product. Personally I would never order from them again, who ever they are.