25 ga 3cc needle leak

[5millionbucks]

So right now I'm using injectable vitamin b12; and something similar to synthelesen; how come when I try to use the 3cc needles shit keeps leaking out; like the fluid keeps leaking out when I inject mid way.

 

[chinaboy]

I'm no brain surgeon but perhaps the contents of the syringe are larger than the diameter of the needle and create pressure past the point in which the articulation of the syringe and needle can withstand.

Try heating your solution, using a larger needle or different brand of syringe.

 

[5millionbucks]

I'm no brain surgeon but perhaps the contents of the syringe are larger than the diameter of the needle and create pressure past the point in which the articulation of the syringe and needle can withstand.

Try heating your solution, using a larger needle or different brand of syringe.

It's basically a 1 inch 3cc insulin like syringe; I filled up the needle to inject in my quad; then half way when I'm pushing it in shit is fucking leaking out of the syringe.

 

[5millionbucks]

by the way it is leaking out of the needle hub; is there something I am doing wrong?

 

[chinaboy]

Insulin needles usually just press into a syringe and do not screw into the syringe. If there is too much pressure in the contents of the syringe it has to give somewhere and it could push the needle off allowing for a leak.

The contents of the solution are probably too big to go through a small insulin needle. Use a larger needle and heat your solution to dissolve the solids a little more. This may help.

 

[5millionbucks]

Insulin needles usually just press into a syringe and do not screw into the syringe. If there is too much pressure in the contents of the syringe it has to give somewhere and it could push the needle off allowing for a leak.

The contents of the solution are probably too big to go through a small insulin needle. Use a larger needle and heat your solution to dissolve the solids a little more. This may help.

The insulin needles; 29ga 1/2 inch are fine they dont leak at all; just these ones do for some reason heres what they look like

https://www.otcwholesale.com/easytouch-09011.html

 

[chinaboy]

I have a feeling I'm being trolled.

 

[Fa Seeshus]

I've had the same thing happen with detachable needles where it will go through a slin pin fine.

You probably need to push the plunger slower. That plus heating will help

 

[Samson250]

I'm no brain surgeon but perhaps the contents of the syringe are larger than the diameter of the needle and create pressure past the point in which the articulation of the syringe and needle can withstand.

Try heating your solution, using a larger needle or different brand of syringe.

Spoken like a brain surgeon lol

 

[Samson250]

I have a feeling I'm being trolled.

You did the right thing regardless. Well done.

 

[5millionbucks]

I figured it out; I tighten the hub before and then shoot out air before drawing and then injecting; that seems to be the solution. Guess this is the way to properly use 3cc; I'm only used to using the insulin 29ga 1cc syringe never the 3cc syringes.

 

[heavyhitter]

So the problem was that you didnt make sure that the needle was screwed onto the syringe tight enough? lol

 

[5millionbucks]

So the problem was that you didnt make sure that the needle was screwed onto the syringe tight enough? lol

I guess so; that and pushing air out also; cause I remember when using it; it took a while for it to draw up the liquid on top; I realize I have to do this with every needle.