I’ve always done it backloading the syringe..
Draw oil with 18G needle and regular 3cc syringe and then pull the plunger out of the Slin syringe (1cc/100iu slin syringe used) and fill up to desired amount and pop the plunger back in with needle facing up obviously...
I load a few at a time so I don’t have to do it every single time I inject..
Well used to.. Been off for like 2 months maybe a bit more now lol
i only do it with about a half cc and i use a 1/2 inch insulin syringe. ill do it pre workout for feeler muscles.
i have a hard time feeling my chest so ill shoot my chest. or my rear delts even side delts.
i do not agree with sub q oil injections. i only do it where i am really really lean
I use either a 29, 30 or 31 gauge everytime. Never backload but also never go over 1ml, usually .5 ml. Its hard to use a syringe larger than 1ml, .5 ml is better if youre doing a smaller dose. You also have to be patient, i pull the syringe to where i want and after a few drops come through, it usually holds the pressure without pulling the stopper back in. Then you just hold it. Im usually doing this during a conf call or while on my computer so waiting 3 or 4 min is no big deal. If you cant be patient then back load.
3 to 4 mins .........Please share with us how you DONT back load a 31g and aren’t there for 3 or 4 days pulling .01 of a cc out of oil????? Is the oils like water wtf and even at that those small ass needles are soo brittle. They bend and dull soo easily when the hit the rubber stopper.
I just busting you balls but damm you have some patience man.
I draw the syringe full of air and push it in. Then turn it upside down and draw it down the 100 (or whatever amount you're looking for) then wait till a lil oil hits the rubber(you'll have to play with a few times and see how much oil it takes) and if it's enough oil there then it will stay pulled back on it's own. I then hang the bottle with the needle sticking down and still slowly pulling oil from a metal portable clothes rack I got that has a shelf and has a small enough gap between the metal wire for the part with needle to get between it and hang but thats tight enough to stop the wide part of the vial from falling through. It will then just hang there own it's own hands free while the oil slowly fills up the syringe. Come back 10 mins or so later and finish off any by hand (often stops with about 1/10 or less of a ml needing to be hand held)... After a time or two of doing it, it's extremely easy and doesn't involve backloading or using other needles to draw....
I've always thought this would be too difficult but it seems like it's gotten fairly popular so I am wondering about the best way to go about it