- Joined
- Dec 11, 2014
- Messages
- 3,661
Not sure, It's white.Are those air bubbles? When you add the BAC water to your GH vial all the white powder should dissolve completely and turn into a clear liquid.
Probably not enough water. Minimum i need to dilute a vial is 0.4mlHow about after putting back water in it, turning it , waiting two hours, turning again, then putting in fridge , then putting it in slin pin, particles sticking to vial?
This isn't a representative picture, it looks like sludge, sometimes
The powder should dissolve after reconstituting, allow more time to settles overnight etc. Personally never had this issue before. Perhaps ask your supplier,On GH loaded slin pin, get white stuff toward the end and the rest clear looking like this. Does this mean that the only GH is at the end?
You didn’t let it reconstitute properly.
Next vial:
1: draw .5-1 ml BAC water into a rig
2: invert the gh vial, slowly push the BAC water into the vial while the vial is inverted (vial vacuum may simply draw in the BAC water in, you may not need to push - either way, do this slowly and avoid jet-streaming the gh with the BAC water)
3: gently roll or swirl the vial, or simply let stand for 5-10 minutes. If you still see gh particles, swirl/roll/wait longer
4: once completely clear and free of gh particles, gently draw and pin
Yep. Invert it too down, so the water pools at the bottom and gently falls onto the gh when you tilt it upright.Just had a quick question about your step 2, Invert as in turn the GH vial upside down (rubber stopper pointing at the floor?) Never heard of this but I guess it would help so the vacuum and gravity doesnt just pull the water right onto the GH, if I am reading step 2 correctly.
Actually it’s genius, never thought to do that. Gona give it a go.Yep. Invert it too down, so the water pools at the bottom and gently falls onto the gh when you tilt it upright.
Maybe overkill but gh is fragile
U need to even out the pressure.When I load my 3ml syringe with one ml of bac water , as soon as I put needle in the rubber it shoots in, automatically so what I'm going to have to do is put it into a slin pin and let it slowly go in bc with bigger needle it shoots out , and there's no way to stop it there and this may be causing it .
The only thing I can see that could cause us I'm doing everything else correctly as far as I know