Highest dose of primo you've ran?

[Celt123456]

So the gram of primo cycle had no test?

No test

I wanted to see how I'd feel going this route of a primo only cycle so I was a bit wary at first. I had Test E and Test P on hand if i felt i needed them but i never used them in the end. After the first few wks and I was happy with how I was progressing and feeling I decided to keep it going as a primo only cycle.

Most cycles I had done before had a least a minimal amount of test (trt amt) apart from an anavar only cycle i tried about 20yrs ago.

 

[Ride'm Cowboy]

2200 a week.

It varied. Anywhere from 500 a week to a gram.

I'm sorry but this was such a waste of primo with test so low. I would bet that the results were not impressive.

 

[Ride'm Cowboy]

Anything above 100-125mg/mL should be painful.

So if primo 200 does not hurt then it is fake?
I do not think that this is true.

 

[Big Dave Smith]

So if primo 200 does not hurt then it is fake?
I do not think that this is true.

Okay

 

[Eddie.]

But I wouldn’t be scared of EQ. Remember primo was once indicated to treat anemia.

I've used 300mg EQ with 600 test and 300mg primo with 600mg test so low-moderate dosages. They both don't bulge my HCT and RBC on this dosage, BUT with primo i have a decent increase in platelets which i'd like to avoid in the future because if HCT and RBC start to creep up too (with higher dosages) it might be an issue.

 

[derzwerg]

Those of you who get PIP, have you tried mixing it with your test? For instance, I'm currently running test:mast 1.5:1 by volume, so I just mixed up a 60ml vial at that ratio. Might help smooth it out?

I have quite a lot of 200mg/ml primo but have never gotten around to trying it.

 

[Big Dave Smith]

Those of you who get PIP, have you tried mixing it with your test? For instance, I'm currently running test:mast 1.5:1 by volume, so I just mixed up a 60ml vial at that ratio. Might help smooth it out?

I have quite a lot of 200mg/ml primo but have never gotten around to trying it.

This issue is… Primo can be made at 200mg, but I speculate…

1- When made with just BB/BA/MCT, the compound forms an irritation in the injection site, causing rock-like knots.

2- If a stronger solvent is used, the solvent may help the oil pocket dissipate faster. If so, the mixture doesn’t hang around in the injection site, causing less irritation… BUT, the systemic inflammation builds up over time and isn’t necessary. It’ll show up as a health marker issue down the road.

I’ve tried 9 different primo brands, of which I’ve tried Bayer amps twice. Never had knots from 100mg. Every version above that would knot, even when mixed.

Many “make your own cake” recipes paired up exactly with the experiences with the UGL and pharm grade. All were tested.

If you want to mix it, lean towards compounds that don’t require high solvents to make… like EQ, test cyp, etc. Even test Cyp is like 20% BB, but is the most painless, non PIP compound next to EQ. EQ requires only oil to dilute and a smidge of BA.

 

[KingOfSushi]

No test

I wanted to see how I'd feel going this route of a primo only cycle so I was a bit wary at first. I had Test E and Test P on hand if i felt i needed them but i never used them in the end. After the first few wks and I was happy with how I was progressing and feeling I decided to keep it going as a primo only cycle.

Most cycles I had done before had a least a minimal amount of test (trt amt) apart from an anavar only cycle i tried about 20yrs ago.

Do you not like testosterone?

 

[juiceball44]

I’ve had 200mg/ml primo that was painless and tested by jano. I was mixing it with test and doing daily shots so that may have been why no pip. I never took it by itself or in large amounts at once

 

[Sectør]

Those of you who get PIP, have you tried mixing it with your test? For instance, I'm currently running test:mast 1.5:1 by volume, so I just mixed up a 60ml vial at that ratio. Might help smooth it out?

I have quite a lot of 200mg/ml primo but have never gotten around to trying it.

Yeah i've tried using coffee mug warmers and also cutting the primo 200 with other "normal" concentration compounds like test e 250 or mast 200, or eq300 -- still knots me up

only thing left for me to try is get some MCT oil and filter it and reduce the concentration of the primo 200 down to 125-150 and im hoping that'll help

 

[Alzadosghost]

This issue is… Primo can be made at 200mg, but I speculate…

1- When made with just BB/BA/MCT, the compound forms an irritation in the injection site, causing rock-like knots.

2- If a stronger solvent is used, the solvent may help the oil pocket dissipate faster. If so, the mixture doesn’t hang around in the injection site, causing less irritation… BUT, the systemic inflammation builds up over time and isn’t necessary. It’ll show up as a health marker issue down the road.

I’ve tried 9 different primo brands, of which I’ve tried Bayer amps twice. Never had knots from 100mg. Every version above that would knot, even when mixed.

Many “make your own cake” recipes paired up exactly with the experiences with the UGL and pharm grade. All were tested.

If you want to mix it, lean towards compounds that don’t require high solvents to make… like EQ, test cyp, etc. Even test Cyp is like 20% BB, but is the most painless, non PIP compound next to EQ. EQ requires only oil to dilute and a smidge of BA.

Iv had tons of primo e that was 200+ mg and I never had one single painful injection. No special solvents used. Lots of people used it no one complained of any pip and just wanted to know where to get more. Sample was tested by jano and came back at 209 mg/ml.

 

[BamaCrazy]

Those of you who get PIP, have you tried mixing it with your test? For instance, I'm currently running test:mast 1.5:1 by volume, so I just mixed up a 60ml vial at that ratio. Might help smooth it out?

I have quite a lot of 200mg/ml primo but have never gotten around to trying it.

I’ve mixed it with my Test C. I’ve heated it up. I’ve increased injection frequency in order to pin less volume. I’ve tried injecting it deeper rather than less shallow. Primo 200 still gives me huge knots and inflammation that lasts 7-10 days. The Primo 150 GSO I used during this cycle still gave me issues but not as often. Primo 100 did not give me issues at all.

 

[PoptartPsycho]

I have run it several times and really saw no difference between 500mg and 800mg.

Can someone tell me how long Primo is good for? I know I have several vials of both 100mg and 200mg Primo stored away in a shoe box in the closet from 2016.

 

[Ride'm Cowboy]

Did a primo only cycle, 1,000mg/wk for about 24wks a few yrs back.

Very cut, consistently stronger each wk on lifts (nothing crazy but consistent progress on all lifts, no plateaus), no hair loss. Cardio also benefitted slightly. Kept protein high.

I would bet that you were consistently the same weight too.

Cialis occasionally for sex drive which decreased only slightly.

Cialis does not affect sex drive.

Probably the most compliments I ever got from random strangers when I was on that particular cycle.

Be careful of this bc in Brazil random strangers give fake compliments before the hit you in the head and take your wallet.

 

[Ride'm Cowboy]

I have run it several times and really saw no difference between 500mg and 800mg.

This is bc you are not eating enough, or bc you are not using enough test with it.

Can someone tell me how long Primo is good for?

A long time if you did not make it yourself.

 

[Celt123456]

I would bet that you were consistently the same weight too.

Cialis does not affect sex drive.

Be careful of this bc in Brazil random strangers give fake compliments before the hit you in the head and take your wallet.

Yep same weight, just body recomp. I wasn't looking for weight gain. I'm not a BBer. Respect to the guys that are but different strokes for different folks.

Cialis, well whatever it affects, it maintained my interest in sex, but whatever u say. Took primo, still wanted sex. Cialis helped.

Compliments were in the gym, haven't seen any muggings yet in the gym but anything is possible.

 

[Flocci]

This issue is… Primo can be made at 200mg, but I speculate…

1- When made with just BB/BA/MCT, the compound forms an irritation in the injection site, causing rock-like knots.

2- If a stronger solvent is used, the solvent may help the oil pocket dissipate faster. If so, the mixture doesn’t hang around in the injection site, causing less irritation… BUT, the systemic inflammation builds up over time and isn’t necessary. It’ll show up as a health marker issue down the road.

I’ve tried 9 different primo brands, of which I’ve tried Bayer amps twice. Never had knots from 100mg. Every version above that would knot, even when mixed.

Many “make your own cake” recipes paired up exactly with the experiences with the UGL and pharm grade. All were tested.

If you want to mix it, lean towards compounds that don’t require high solvents to make… like EQ, test cyp, etc. Even test Cyp is like 20% BB, but is the most painless, non PIP compound next to EQ. EQ requires only oil to dilute and a smidge of BA.

Maybe mixing it with some castor oil could help as it can act as an antiinflammatory, it also would increase the halflife a bit depending on how much is used. Lets say 20-40% castor oil with the rest being MCT with 20-30% benzyl benzoate. Do we have any chemists here? lol

 

[madg]

Maybe mixing it with some castor oil could help as it can act as an antiinflammatory, it also would increase the halflife a bit depending on how much is used. Lets say 20-40% castor oil with the rest being MCT with 20-30% benzyl benzoate. Do we have any chemists here? lol

Norma using castor oil in test e

Interesting didnt know this

Thanks

 

[Flocci]

Norma using castor oil in test e

Interesting didnt know this

Thanks

i forgot to mention that the castor oil is very thick, but thats why you'd mix it with some MCT so it doesnt get too viscous. Its never fun having to spend 3 minutes pinning half a cc and having your hand cramp up halfway.

 

[Massive G]

Never used primo or masteron. Not interested in crashing my estrogen or shedding my hair. Do just fine on bread and butter steroids. IMO super low estrogen and using dry steroids like primo and masteron and winstrol open you up to muscle tears.
A lot of pros are posing with weights in their gym studios on their leverage machines with super slow reps to avoid muscle tears.
Nick Walker is a prime example partially tearing his hamstring standing up after doing inclines.To each their own though.