• All new members please introduce your self here and welcome to the board:
    http://www.professionalmuscle.com/forums/showthread.php?t=259
Buy Needles And Syringes With No Prescription
M4B Store Banner
SPC-210x65
Riptropin Store banner
Generation X Bodybuilding Forum
Buy Needles And Syringes With No Prescription
Buy Needles And Syringes With No Prescription
Mysupps Store Banner
IP Gear Store Banner
Anabolic Hormones Store Banner
Ganabol Store Banner
Spend $100 and get bonus needles free at sterile syringes
Professional Muscle Store open now
LandmarkChem Email Banner
Medtech Store Banner
Bruce Labs Store banner
gd
Professional Muscle Store open now
over 5000 supplements on sale at professional muscle store
granabolic123
Blackroids-animated-optimized-number-1
over 5000 supplements on sale at professional muscle store
over 5000 supplements on sale at professional muscle store
over 5000 supplements on sale at professional muscle store
over 5000 supplements on sale at professional muscle store
over 5000 supplements on sale at professional muscle store
over 5000 supplements on sale at professional muscle store
over 5000 supplements on sale at professional muscle store

Low MG crashed test c

1bigpapapump1

Verified Customer
Registered
Joined
Jul 22, 2017
Messages
652
So i have heard about the high concentration stuff crashing, but not 250mg test cyp. My general concern is getting it back to liquid state. To be honest, i have never dealt with crashed gear. Is it as simple as sitting vial in cup of hot water?
 

mike036

Featured Member / Kilo Klub
Featured Member
Kilo Klub Member
Registered
Joined
Aug 14, 2008
Messages
2,919
So i have heard about the high concentration stuff crashing, but not 250mg test cyp. My general concern is getting it back to liquid state. To be honest, i have never dealt with crashed gear. Is it as simple as sitting vial in cup of hot water?

Test cyp is notorious for crashing.Put vial in a shallow pan ,fill with a small amount of water and heat until it goes back into solution
 

johnjuanb1

Featured Member / Sponsor Rep
Featured Member
Kilo Klub Member
Registered
Sponsors
Joined
Mar 6, 2009
Messages
25,950
So i have heard about the high concentration stuff crashing, but not 250mg test cyp. My general concern is getting it back to liquid state. To be honest, i have never dealt with crashed gear. Is it as simple as sitting vial in cup of hot water?

I just got a bottle of crystallized/crashed liquid exemestane back in solution by microwaving it. 15 seconds in the microwave makes a glass vial scolding hot so be very careful. I feared it would explode. It worked though. If it doesn’t fully go into solution i would wait until it cools then nuke it for another 10 seconds. Mine took 3 attempts, 15 sec, 10 sec, 10 sec to fully go into solution.
 
Last edited:

1bigpapapump1

Verified Customer
Registered
Joined
Jul 22, 2017
Messages
652
I just got a bottle of crystallized/crashed liquid exemestane back in solution by microwaving it. 15 seconds in the microwave makes a glass vial scolding hot so be very careful. I feared it would explode. It worked though. If it doesn’t fully go into solution i would wait until it cools then nuke it for another 10 seconds. Mine took 3 attempts, 15 sec, 10 sec, 10 sec to fully go into solution.


I thought about the microwave thing, but the top around the vial is metal.
 

bigpoppajr

Member
Registered
Joined
Aug 30, 2010
Messages
128
Aluminum cap

It is 100% safe to put a vial in the microwave with an aluminum top. And an old Cyp box I had even had this warning about solidifying in cold weather.
 

Big Vin

Well-known member
Registered
Verified Customer
Joined
Aug 27, 2011
Messages
1,224
You don't even need the water, just put the vial in the sauce pan . I've heated a lot of gear in my time...no water and make sure you vent it. Keep an eye on it...easy,
 

maldorf

Featured Member / Kilo Klub
Featured Member
Registered
Joined
Mar 16, 2007
Messages
22,724
You don't even need the water, just put the vial in the sauce pan . I've heated a lot of gear in my time...no water and make sure you vent it. Keep an eye on it...easy,

It would be better to use water because it heats the vial more evenly. I think you run a risk of getting the bottom too hot and then the sides are colder, it could crack the vial. Just be careful that if you get the water hot enough to boil the bubble will most likely knock the vial over and it could submerge in the water. Going under water could cause water to enter your vial and spoil it. Shouldn't have to get the water that hot. Ive done it in the past. No issues. If it gets real hot youll want to vent the vial with a pin so it doesn't pop off the stopper. or explode.
 
Last edited:
D

Deleted member 121863

Guest
if you got test cyp 250 that crashed, ditch that crap and bitch those people out for a refund. There is ZERO reason for that to crash or hurt if done properly. Those people obvious are amateurs. I don`t understand trying to "fix it" when it was obviously made incorrectly. What else did they overlook? If you can`t get simple ratios and math right I would question things even being sterile.
 

Big Vin

Well-known member
Registered
Verified Customer
Joined
Aug 27, 2011
Messages
1,224
It would be better to use water because it heats the vial more evenly. I think you run a risk of getting the bottom too hot and then the sides are colder, it could crack the vial. Just be careful that if you get the water hot enough to boil the bubble will most likely knock the vial over and it could submerge in the water. Going under water could cause water to enter your vial and spoil it. Shouldn't have to get the water that hot. Ive done it in the past. No issues. If it gets real hot youll want to vent the vial with a pin so it doesn't pop off the stopper. or explode.

It's never cracked or gotten too hot...that's why you use low heat and do it slowly.Always vent as well.
I guess either way works, you just need to be careful.
 

Big Vin

Well-known member
Registered
Verified Customer
Joined
Aug 27, 2011
Messages
1,224
I don't trust gear that isnt brewed right to be sterile.

Got news for ya...you've probably injected more non sterile stuff than you could think of. Clean technique is used...but not sterile, a lot of times. Just the way it is.
 

maldorf

Featured Member / Kilo Klub
Featured Member
Registered
Joined
Mar 16, 2007
Messages
22,724
It's never cracked or gotten too hot...that's why you use low heat and do it slowly.Always vent as well.
I guess either way works, you just need to be careful.

Yeah, I think it would be best to put the vial in the pan then turn on the heat if you aren't going to use water. Heating would be slow that way.
 

1bigpapapump1

Verified Customer
Registered
Joined
Jul 22, 2017
Messages
652
So i'm definitely gonna vent the vial, place lil water in pan and slowly heat up if i choose to try and get it back into liquid state. But hogan86 comment got me thinking. Might not even be worth it.
 
Last edited:

1bigpapapump1

Verified Customer
Registered
Joined
Jul 22, 2017
Messages
652
if you got test cyp 250 that crashed, ditch that crap and bitch those people out for a refund. There is ZERO reason for that to crash or hurt if done properly. Those people obvious are amateurs. I don`t understand trying to "fix it" when it was obviously made incorrectly. What else did they overlook? If you can`t get simple ratios and math right I would question things even being sterile.

I was definitely surprised to see a low mg like this crashed. I do have plenty of other non crashed cyp on hand. I may just toss it.
 

Bio

Moderator
Staff member
Moderator
Registered
Joined
Oct 6, 2007
Messages
6,148
I don't trust gear that isnt brewed right to be sterile.

Crashed gear doesn't mean it's not sterile. If coconut oil is used, it can congeal in colder climates.
 

mike036

Featured Member / Kilo Klub
Featured Member
Kilo Klub Member
Registered
Joined
Aug 14, 2008
Messages
2,919
if you got test cyp 250 that crashed, ditch that crap and bitch those people out for a refund. There is ZERO reason for that to crash or hurt if done properly. Those people obvious are amateurs. I don`t understand trying to "fix it" when it was obviously made incorrectly. What else did they overlook? If you can`t get simple ratios and math right I would question things even being sterile.

I wouldn’t go that far to say it was made incorrectly.Written on the box of pharma Perrigo testosterone cypionate

https://imgcdn.mckesson.com/CumulusWeb/Images/High_Res/734891.jpg
 

K1

Blue-Eyed Devil
Staff member
Administrator
Moderator
Kilo Klub Member
Registered
Joined
Sep 2, 2005
Messages
10,299
Crashed gear doesn't mean it's not sterile. If coconut oil is used, it can congeal in colder climates.

Agreed...Two totally separate topics.

I wouldn’t go that far to say it was made incorrectly.Written on the box of pharma Perrigo testosterone cypionate

https://imgcdn.mckesson.com/CumulusWeb/Images/High_Res/734891.jpg

Anyone that has used gear made with or made gear with shit like EO, Coconut oil, MCT all have seen crashed gear, especially during winter...No amount of expertise is going to stop the weather from attacking the carrier oil!
 
D

Deleted member 121863

Guest
Agreed...Two totally separate topics.







Anyone that has used gear made with or made gear with shit like EO, Coconut oil, MCT all have seen crashed gear, especially during winter...No amount of expertise is going to stop the weather from attacking the carrier oil!


Somebody with experience, does not use, or need to use any of that stuff for 250cyp.



Sent from my iPhone using Tapatalk
 

Staff online

  • pesty4077
    Moderator/ Featured Member / Kilo Klub

Forum statistics

Total page views
506,809,596
Threads
124,402
Messages
2,396,641
Members
155,641
Latest member
grim3y1
Top