Recently bought from a sponsor on here a few weeks ago Test E300 and Bold U300. Was using Test E250 and Mast P100 with no problem but whenever I’ve used the Test E300 I’ve been getting a decent amount of PIP and low-grade fever immediately after.
Slightly confused because whenever I use the Bold no problems at all. I’m shooting 1mL of the Test and .5mL of the Bold so going to break my test up into .5mL shots to see if it helps
SubQ 27g 1/2” needle, the only thing I can think of is 1mL is too much injection volume for SubQ. Any suggestions appreciated
Quite a few people have been reporting these exact problems from various different sponsors on the board, including myself..
Did a 0.5ml shot of Test E 5-6 days ago and can still barely sit or lay on that side, had my body fighting a light fever for 3 days and body aches, taking Tylenol and Ibuprofen and HS-CRP came back super elevated 2 days post injection..
I’m honestly starting to believe more and more the “rumors” that there was not only a supply chain issue of raws but also a quality control and possible contamination issue..
Of course the sponsors/sources will most likely deny the shit out of this as it interferes with business, and we all like to think that AAS dealers/manufacturers are all good hearted bros just like us and completely different from your average drug dealer that doesn’t care if his product is pure or laced or whatever..
That’s rarely ever the case.. Their bottom line is profit profit profit.. Its a business with no corporate complaint department or HR etc.. There are no rules and even for smaller things, I’ve never ever in my 13+ years here, have ever seen a source/sponsor ever take responsibility for things they 100% proven did wrong (reference random AAS testing for several examples)….
So imagine something as big as this..
You’re like the 20th person I’ve seen say something like this, whether on public forum or in private, in the last week alone..
You can TRY to heat the gear in a pressure cooker or oven and filter the gear into a sterile vial with .22 micron filters, which would take care of most possible bacteria or particles that may have been left behind due to poor SOPs, but in the slight chance it’s something like endotoxins, which can’t be filtered through standard filtering processes or killed by heat unless it’s extreme heat (above 500-600° for an hour) then you’ll more than likely still get the same reaction after the fact..
Only way to know is to try it out..
