Question about baking test...

[getcater]

I need to bake my test Enanthate since the injection is too painful and make my ass swallon.

However, i don't know how to bake it.. and how to check the Temp either.

Do i need to boil water and put the vial into the pan? Is that all?
And i can inject the hot test right away into my glute??

 

[The Jackal]

pre heat oven 200 degrees, place vial in the oven for 5 min. Use oven mitt to take out the vial from the oven. And drawl from vial

 

[Jim550]

you can heat it at a much higher temperature and longer that, it will not hurt the gear. I bake it at 350 for about 50mins to 1hr. When you take it out of the oven immediately stick the stopper with a needle (not the whole syringe just the needle) and this will release the pressure and the ba vapors after venting it for about 10-15 seconds take the needle out and your good to go.

 

[powerclean2]

I need to bake my test Enanthate since the injection is too painful and make my ass swallon.

However, i don't know how to bake it.. and how to check the Temp either.

Do i need to boil water and put the vial into the pan? Is that all?
And i can inject the hot test right away into my glute??

why is the test e painful? what lab is it?

 

[mcswag]

how does baking it make it less painful? I'd assume if you had painful test E it would be because of too much BA or some solvent, I didn't know you could change that with heat

 

[E.J.]

I agree with matty, I think ur wasting ur time.

 

[Jim550]

how does baking it make it less painful? I'd assume if you had painful test E it would be because of too much BA or some solvent, I didn't know you could change that with heat

It does make it less painful, it burns off some of the BA making it less painful. I've done it several times, and it definitely works.