Suspension injection problem

[GlobalLJA]

Tried injecting suspension and when i tried pushing the plunger it didn't move and the suspension couldn't get out. I then reinjected my self for the second and finally on the third the testosterone finally came out. I've never had a problem with other testosterones . Im currently using a 23 or 25 gauge for this. Has this happened to you before. I also store the suspension in my fridge because I live in a hot climate area .

 

[richiec]

Did you heat the suspension prior to injecting? Many times the suspension will crystalize/crash and heating it will allow it to pass through the pin easier
Isn't there a cool and dry place you can keep it? Maybe a drawer or something rather than the refrigerator?

 

[cardealer]

On that one I pin with a 21 gauage.

 

[GlobalLJA]

Its in the fridge now taking it out and storing it at room temperature will be ok?

Synthetek Industries – Innovative Bodybuilding Products: Syntherol SEO | Human Kyno | L-Carnitine | Liver Protectants | Appetite Stimulators | Vasodilators - www.synthetek.com

 

[GettingBackIn]

Sounds like you have good suspension. The crystals are big and will clog the needle.

 

[ALLEX]

Throw it away and get some TNE.

Suspension is just too painful and too risky.

 

[GreenEarth]

On that one I pin with a 21 gauage.

Ouch.

 

[BigDM]

Its in the fridge now taking it out and storing it at room temperature will be ok?

Synthetek Industries – Innovative Bodybuilding Products: Syntherol SEO | Human Kyno | L-Carnitine | Liver Protectants | Appetite Stimulators | Vasodilators - Synthetek Industries - Innovative Bodybuilding Products

Room temp is fine. You can also run the vial under some warm water before pulling it into the syringe. Obviously the largest size needle you can use would help. I never have to use anything under a 25g.

 

[collinb]

Suspension is crystallized and often clogs the needle.
I like to use slin pins for suspension simply because you can put greater pressure on the plunger and have found that it is much easier with slin pins than 25g for some reason the 25g always clogs or is slow...with slins takes seconds to pin a ml.

Store at room temp, shake before drawing, and do not throw it away lol