How do you go about injecting BAC water into an vial without it squirting into and being sucked into the vial. Am I suppose to inject air into it first or suck air out first?
1. Pull plunger back to 3cc, push through the stopper, and let the vial suck the air in.
2. Draw desired amount of water
3. Push pin through the stopper at an angle, so that the pin touches the side of the vial.
4. Slowly inject water so that it runs down the side of the vial.
5. Gently swirl to mix.
1. Pull plunger back to 3cc, push through the stopper, and let the vial suck the air in.
2. Draw desired amount of water
3. Push pin through the stopper at an angle, so that the pin touches the side of the vial.
4. Slowly inject water so that it runs down the side of the vial.
5. Gently swirl to mix.