Hi, I have ten vials of 0.1 mg folli each.
what is the best protocol to follow??
regards
if you are ten of 0.100mg = 1 mg in total, it is divided into vials of 0.100mg
so no problem with degradation.
You wil get nothing out of .1 mg........you need to research the whole 1 mg at once.
You wil get nothing out of .1 mg........you need to research the whole 1 mg at once.
not to hijack but I have similar question about myo.
Can't you just dose slin pins and put in freezer so you wont have to use all in one shot kinda like mgf storage? I ask this because what if you want to shoot the myo in differen't areas through out the week rather than just once.
Id like to do one vial dosed through out the week as below.
Mon. biceps (inner and outter heads)
tues. shoulders/divided in side and front heads.
wed. quads/butt
thurs. upper chest/triceps
As far as this post, if he did have 1mg couldn't he do what I'm hoping by freezing dosed pins?
Just really would like to get benefits in differen't muscles. But I guess myo is more of a builder than folli, so maybe his case is different.
MYO HMP is systemic, so do not waste it in various sites in many slin needles. One time deal.....then wait.........how long is dependent on variables............a week? 5 weeks?
You wil get nothing out of .1 mg........you need to research the whole 1 mg at once.
You mean I have to inject 1 mg of Folli once?
What kind of Follistatin have you purchased? If it is FS-344 it will most likely do nothing. If it is FS-315 expect some huge MF gains.
What kind of Follistatin have you purchased? If it is FS-344 it will most likely do nothing. If it is FS-315 expect some huge MF gains.
That would be a week later. If lab funds are good, I would administer my subjects 2mg a week. That would be interesting.
It was run 1mg per week for 6 weeks.