quick question

[nspaletta]

so i have done my fair share of cycles and do know what i am doin. though is for the first time ever i had some oil leak out of the injection site...about a tenth of a cc if i was to say. my question is what causes this to happen? was i not in deep enough or maybe just too much in that area. it was a cc and a half to the delt

 

[xskater]

try going a little deeper next time, but not to much, check the sticky on needle sizes ect. How slow did you go?

 

[kscowboy]

I use to have this happen before i knew how to inject. Your needle isnt long enough. You got the oil in the fatty tissue and not in the muscle tissue.

Glutes need 1 1/2"
Quads need 1"

 

[kscowboy]

Also it isnt that big of a deal. Your body will still absorb it (Takes a little longer) but it will still use it. But you do need longer needles.

 

[Flex2019]

If you don't want it happening, consider using a "z-track injection", holding the skin laterally to the side about an inch before inserting the needle. When you release the skin upon removing the needle, the oil will be sealed in.

**broken link removed**

 

[nspaletta]

no the needle was definitely long enough. i use 1 1/2" on everything. i might have not gone in deep enough though. i always inject slow too, im in no rush for it. and next time i think i'll try that method flex thanks

 

[kscowboy]

1 1/2" burried all the way to the cap of the needle should be fine.

 

[RV63T]

pull up on the skin at the site inject remove needle let skin go acks like a trap door. problem solved.

 

[nspaletta]

cool guys...thank you all for the advice