Help tren crashed

[aufootballar9911]

I recently made tren with EO at 100mg/ml done this several times same recipe no problem. This time it is a little cloudy after sitting for a while. It goes back into solution just by swirling it. I also heated and it went back, but then crashed again. Should I try cutting it with BB? Also if by heating and swirling it goes back can I just do this before every injection? Any help would be appreciated.

Thanks

 

[mexbeast]

yes, you could use a little bb maybe something like 2-5%. sometimes a little bit of the binders might go into solution and make it look a little cloudy, but if you can not see crytals i would just shake it and use it another thing, does it hurt and get irritated? if its not to bad it should be ok.

 

[aufootballar9911]

No crystals it is just clouded.. . almost like the powder is just suspended in the oil.