IGF AND AA

[gridlock]

AGAIN...........

i know this has been asked over and over and i've searched for it but still cant find the answer. my source for igf gets it to me in a 1mg vial (annoying i know as I'd prefer the 10x100mcg vials but at the price i pay i cant be too choosy) either way, has anybody since discovered anywhere that stocks AA that is ready and has the right ph to mix with it? I really dont fancy making it up myself as i am a danger unto myself

 

[rippedfreak123]

not stealing your thread bro but wats wrong with BW?? i used it several years back and worked great on me...i sdee alot of hype on it now

 

[gridlock]

you need to mix igf with acetic acid if you are leaving it for a while.

it will break down if left in Baccy water over time. anything over a week (i think) and you're bang in trouble as it probably wont last that long.

in a 1mg vial its gonna need to be stable for quite a few weeks so it needs the AA

 

[pesty4077]

you need to mix igf with acetic acid if you are leaving it for a while.

it will break down if left in Baccy water over time. anything over a week (i think) and you're bang in trouble as it probably wont last that long.

in a 1mg vial its gonna need to be stable for quite a few weeks so it needs the AA

Try about 24 hours, Nacl will last when mixed 4-6 weeks. AA lasts alot longer, a little more discomfort, though.

 

[gridlock]

yeah i've noticed the sting with this lot i've got at the minute. i did one in the leg earlier and it really fucking hurt. i had trained legs earlier so was probably the reason

i've got enough for another two vials left but i dont wanna be caught out when i need to go on to the next cycle

 

[papapumpsd]

Grid, I hear you on the AA for reconstitution. I am making mine from the classic vinegar "recipe". There is not a source of pre-made 0.6% AA. I have found more concentrated AA, but you still need to dilute and filter through a 0.2-0.22um Whatman syringe filter.

I am not familiar with the NaCl reconstitution. I have only studied the AA version and plan on running that even though I will only be reconstituting 1mg IGF-1.

FYI, here's my post from another board. Use at your own discretion!

I. Making 0.6% acetic acid solution from vinegar:
A) Mix 1mL vinegar with 7.5mL water (1 part vinegar to 7.5 parts water)
B) Attach a 0.20-0.22um sterile Whatman filter to the end of a syringe, then a sterile needle to the end of the Whatman filter
C) Swab the top of a STERILE vial (let dry)
D) Inject the 8.5mL solution into a STERILE vial

II. IGF-1 reconstitution:
A) Swab the top of the IGF-1 vial with an alcohol pad (let dry)
B) Gently introduce 1mL of the 0.6% AA solution made in part I. above. (This yields 1mg/mL solution)
C) Swirl the mixture gently until it is clear and free of visible solid IGF-1

III. Back-loading with BW prior to injection using a 0.5mL slin pin:
A) Swab BOTH tops of the IGF-1 vial and bacteriostatic water vial/bottle with an alcohol pad (let dry)
B) Using a new, sterile 0.5cc slin pin, draw the IGF-1/AA solution up to the 4th tick mark (yielding 40mcg of IGF-1)
C) Draw BW to the 20th "tick" mark. This will yield a ~4:1 dilution of BW:IGF-1/AA

IV. Injection:
A) swab the injection sites with an alcohol pad (let dry)
B) Inject 1/2 (ONE HALF) the IGF-1 solution into each side (example: 20mcg into right bicep, 20mcg into left bicep)
C) Dispose of syringe into appropriate container and get your swole on

Good luck bro! :s:ar-wars

 

[gridlock]

Grid, I hear you on the AA for reconstitution. I am making mine from the classic vinegar "recipe". There is not a source of pre-made 0.6% AA. I have found more concentrated AA, but you still need to dilute and filter through a 0.2-0.22um Whatman syringe filter.

I am not familiar with the NaCl reconstitution. I have only studied the AA version and plan on running that even though I will only be reconstituting 1mg IGF-1.

FYI, here's my post from another board. Use at your own discretion!

I. Making 0.6% acetic acid solution from vinegar:
A) Mix 1mL vinegar with 7.5mL water (1 part vinegar to 7.5 parts water)
B) Attach a 0.20-0.22um sterile Whatman filter to the end of a syringe, then a sterile needle to the end of the Whatman filter
C) Swab the top of a STERILE vial (let dry)
D) Inject the 8.5mL solution into a STERILE vial

II. IGF-1 reconstitution:
A) Swab the top of the IGF-1 vial with an alcohol pad (let dry)
B) Gently introduce 1mL of the 0.6% AA solution made in part I. above. (This yields 1mg/mL solution)
C) Swirl the mixture gently until it is clear and free of visible solid IGF-1

III. Back-loading with BW prior to injection using a 0.5mL slin pin:
A) Swab BOTH tops of the IGF-1 vial and bacteriostatic water vial/bottle with an alcohol pad (let dry)
B) Using a new, sterile 0.5cc slin pin, draw the IGF-1/AA solution up to the 4th tick mark (yielding 40mcg of IGF-1)
C) Draw BW to the 20th "tick" mark. This will yield a ~4:1 dilution of BW:IGF-1/AA

IV. Injection:
A) swab the injection sites with an alcohol pad (let dry)
B) Inject 1/2 (ONE HALF) the IGF-1 solution into each side (example: 20mcg into right bicep, 20mcg into left bicep)
C) Dispose of syringe into appropriate container and get your swole on

Good luck bro! :s:ar-wars

Thanks dude thats perfect.

I swear I remember your name from some other boards i was on a few years ago

 

[papapumpsd]

Enjoy bro! I have put a lot of effort into getting all this "reconstitution", "Dilution", "back-loading", "storage", etc stuff down ICE FUKING COLD!

I would recommend to you that you run the back-loading instructions by your favorite resident expert before putting into action what I have posted. While it is not absolutely necessary to dilute with BW (it would be HIGHLY foolish not to), a 1:4 dilution may not be to your liking. I have not personally done it yet, so I may back-load more. So please, get a 2nd opinion on my calculations and on the methodoligy. ;D

Please remember, I'm using a 0.5cc slinpin! Bobas has provided you with a good info on what to do with a 1cc pin. I think you should be all set. Best of luck to you. :star-wars