Cutting Test Prop

[Amino_man]

I have some Sesame Oil with 9% BA. I bought it about 6 months ago in case I might need it for my cycle and sure as shit. My TProp makes me feel like I got kicked like a mule 2 days later.

So time to crack open the oil to cut the pain a tad. My question is:

Did I accidentally by oil ready to add Testosterone to it and the BA is the part of the equation that hurts from the injection in the first place or am I good to go at .5mg per mg of T Prop?

 

[Quad-smack]

T-prop itself is painful. BA is worse, IMO. The 9% BA in that Sesame oil will not help your situation...

 

[Dens228]

What is a good % of BA to minimize pain?
2%?

 

[strognarm]

9% ba sounds scary. It can hold in 2% with grapseed. I wouldnt do anything prop over 3%. Thats just asking for trouble

 

[Quad-smack]

What is a good % of BA to minimize pain?
2%?

1 to 2%

 

[Cito33189]

I read alot about palumbo's methods and he recommonds enth cyp or sust. Is test just test and I tried prop once and it was painful I didnt like it. Im dieting for a show now and have enth and cyp Ill switch it up every 3 weeks to keep things new my body seems to respond well to this. Prop was good for the lack of water retention though but if you cut your test right before a show I dont see a problem

 

[skulbone]

You sure its not .9% b/c that's what big pharma uses.

 

[Amino_man]

Is it cool to post where I got it from?

It just says:

Sesame Oil
9% BA
50cc USP Grade

 

[SantiagoMuscle]

.

 

[Amino_man]

That's what I ended up doing. I would still like to figure out if someone was selling it like this, if it makes it a legit dosage of BA or not. Just for the science aspect of it all.

 

[Amino_man]

My new oil is on its way. How strong do you cut it? like 3.0 ml of oil for every 3cc AAS?

I mean, as far as mixing goes... Sucking it up with each 3ml barrel should also help in the mixing process.

I know I could just play with it to see when my pain would stop but right now it's debilitating me to the point where I can not even workout right now.

I'm shooting 3cc's normally, all I have to do is add that to an empty vial, add in my extra oil, heat on coffee cup warmer for 30 minutes with a needle stuck in the vial for a heat vent, and serve while still warm correct?

 

[Quad-smack]

Unless it is USP sterile, it would be a good idea to filter with a quality .45 micron filter.
Start off with 1ml of oil added to 2ml of product. If that does not quite do it, then go 1.5 to 1.5.

 

[Amino_man]

Based on this disclaimer would you feel the need to refilter your oil?

Please Note: Although all of the oils we sell are all originally USP grade, they are purchased in bulk containers and re-bottled. The re-bottling process takes place in a very clean environment, with the utmost care for maintaining the product's purity. However, since the re-bottling process does not take place in an FDA certified clean room, these products are technically no longer USP grade. However, we guarantee the original potency of all re-bottled products.

From: RLS

It also says: This oil has been filtered through a .22um sterile filter.

If it's gtg then I don't want to filter it if I don't have to. They seem legit so if you were in my position and (If you have already purchased with them) what would you do?

 

[JeffD]

Based on this disclaimer would you feel the need to refilter your oil?

Please Note: Although all of the oils we sell are all originally USP grade, they are purchased in bulk containers and re-bottled. The re-bottling process takes place in a very clean environment, with the utmost care for maintaining the product's purity. However, since the re-bottling process does not take place in an FDA certified clean room, these products are technically no longer USP grade. However, we guarantee the original potency of all re-bottled products.

From: RLS

It also says: This oil has been filtered through a .22um sterile filter.

If it's gtg then I don't want to filter it if I don't have to. They seem legit so if you were in my position and (If you have already purchased with them) what would you do?

I purchased my sterile grapeseed oil from them. comes in a nice amber crimped vial. I used it right out of there, no additional filtering. Been using for 5 weeks with no problems and more importantly, no pain. It's GTG, clean and clear right out of the vial. I also bought all my syringes, vials & needles from them. Quality stuff.

 

[Amino_man]

Okay, well I bought the $115 dollar Liter plastic bottle with a twist off cap. My only way of putting this oil into a few 50 ml presealed vials is to stick a 10 cc barrel into the oil suck out the oil and inject it into the vial.

With their disclaimer, and with me using rubber gloves, the oil should be safe to use with out having to re-filter it correct? :a:tion-sm

 

[nukeM]

Okay, well I bought the $115 dollar Liter plastic bottle with a twist off cap. My only way of putting this oil into a few 50 ml presealed vials is to stick a 10 cc barrel into the oil suck out the oil and inject it into the vial.

With their disclaimer, and with me using rubber gloves, the oil should be safe to use with out having to re-filter it correct? :a:tion-sm

Anytime you expose it to the open air you run the risk of some form of contamination.I would have bought a few Whatman filters ,some sealed 50ml vials ,a couple of 25ml syringes & a $7.00 1 liter bottle of GSO from the super market & saved myself about $90,& spent a small amount of time to filter my own into sterile sealed vials.Giving myself piece of mind that it is & will stay sterile.

 

[Ulamalop]

Short esters are a bitch. If you had 9%BA, acting as a co-solvent with the oil, the BAS is very soluble in water, and will flush out of depot, quickly, after injected. I'd try to get 15 to 20%BB, 2%BA, then oil/hormone.

 

[JeffD]

Okay, well I bought the $115 dollar Liter plastic bottle with a twist off cap. My only way of putting this oil into a few 50 ml presealed vials is to stick a 10 cc barrel into the oil suck out the oil and inject it into the vial.

With their disclaimer, and with me using rubber gloves, the oil should be safe to use with out having to re-filter it correct? :a:tion-sm

There is more chance of contamination that way, but you'd probably be okay. Just keep the surface your working on as clean as possible and recap the liter bottle after each withdrawl. I'd keep wiping the stopper on the vials periodically with alcohol preps too to keep them clean. Just work quickly and carefully.

 

[Amino_man]

There is more chance of contamination that way, but you'd probably be okay. Just keep the surface your working on as clean as possible and recap the liter bottle after each withdrawl. I'd keep wiping the stopper on the vials periodically with alcohol preps too to keep them clean. Just work quickly and carefully.

Thanks bro. I'd hate to get an abscess but it was my only option once I bought the $115 dollar bottle of oil. We shall see if I escape contamination all for my goal to look freaky.

 

[JeffD]

Just keep your eye on the vials. If they start looking funky or cloudy, dump them. I'm sure you'll be fine if you're careful about the transfer.