Warm vs Cold GH

[PRGro]

Sup guys,

After reading around for a while and experimenting it appears that letting the GH warm up a bit before pinning really makes it hurt less, less bruising, etc. I usually let it sit inside the pin at room temp (80F) for about 10 minutes before giving it a go. I know GH breaks down if it is not refrigerated, what do you guys think of this?

 

[ericraven2003]

Not sure what you are talking about. In almost two gears of gh/peptide use, I have never had any pain due to injection.

 

[PRGro]

I base my comments on numerous Slin pinning guides. Most state not to pin cold slin; let it warm up a bit. I'm sorry for not being clear, it's basically related to the initial pinning pain; nothing related to long term pain, etc. I know its negligible pain, sometimes none at all, and I might be being a big pussy here but thought that if it didn't really affect the GH, then the convenience might be worth the warm up.

I do feel that the colder the GH the more I feel the pin.

 

[J.Blaze]

The only time I ever had pain was when I went in sideways. Had a bruise on my stomach. Never had any pain besides that one time. Are you sure you are using legit stuff?

 

[bluestrm]

You shouldn't notice any pain at all. Unless you have a really unsteady hand.
I wouldn't let it sit before use.

 

[the_warrior]

Sorry, but you really are just being a pussy

 

[wasp]

The only time I ever had pain was when I went in sideways. Had a bruise on my stomach. Never had any pain besides that one time. Are you sure you are using legit stuff?

arent you supposed to go in sideways?too deep in the fat is not good either

 

[knucklehed]

LMAO,
serious?
whatever

 

[PRGro]

Been going straight from the fridge.... thanks to everyone who shared their input.

On a side note, it's hysterical to see some bashing on the thread. I have seen 40+ post threads on how to be the gentlest vial “swirler”, on the diff between 29g & 30g pins, 4C vs. 8C fridge temps, etc. To some extent most on these boards are over analyzers, myself included.

 

[Ashop]

Sup guys,

After reading around for a while and experimenting it appears that letting the GH warm up a bit before pinning really makes it hurt less, less bruising, etc. I usually let it sit inside the pin at room temp (80F) for about 10 minutes before giving it a go. I know GH breaks down if it is not refrigerated, what do you guys think of this?

Ive never had much pain if any at all with HGH injections.
If leaving it out for 10 min prior helps you out I see no
problems with this.

 

[dugout]

H-mmmmm

Its mailed to you! So its out for atleast 5+ days there another 10 minuts aint gonna hurt the GH. Ive used many different brands of GH never ever had pain bro! Might want to check with your source about that!!

 

[smashey]

How many IUs are you injecting?

I only do 2 and go straight from the fridge, no problem.