Buy Needles And Syringes With No Prescription
M4B Store Banner
intex
Riptropin Store banner
Generation X Bodybuilding Forum
Buy Needles And Syringes With No Prescription
Buy Needles And Syringes With No Prescription
Mysupps Store Banner
IP Gear Store Banner
PM-Ace-Labs
Ganabol Store Banner
Spend $100 and get bonus needles free at sterile syringes
Professional Muscle Store open now
sunrise2
PHARMAHGH1
kinglab
ganabol2
Professional Muscle Store open now
over 5000 supplements on sale at professional muscle store
savage
granabolic1
napsgear-210x65
monster210x65
over 5000 supplements on sale at professional muscle store
over 5000 supplements on sale at professional muscle store
DeFiant
UGFREAK-banner-PM
STADAPM
yms-GIF-210x65-SB
over 5000 supplements on sale at professional muscle store
over 5000 supplements on sale at professional muscle store
wuhan2
dpharma
marathon
zzsttmy
over 5000 supplements on sale at professional muscle store
over 5000 supplements on sale at professional muscle store
azteca
pentech
advertise1x
PCT-Banner-210x65
over 5000 supplements on sale at professional muscle store
over 5000 supplements on sale at professional muscle store
over 5000 supplements on sale at professional muscle store
over 5000 supplements on sale at professional muscle store
over 5000 supplements on sale at professional muscle store
over 5000 supplements on sale at professional muscle store
over 5000 supplements on sale at professional muscle store

what should I use/ do you use to re-filter UGL gear (oil) whatman .45 or .22 filter??

whatman .22 or .45

  • .22

    Votes: 11 55.0%
  • .45

    Votes: 9 45.0%

  • Total voters
    20

juced_porkchop

New member
Registered
Joined
Jan 28, 2008
Messages
483
I have had some tell me .45 and some tell me .22.

I have a bunch of ugl gear somthing like:
50ml trenE
50ml deca
40ml test (some cyp,Eth and sust typ mix)
10ml trenA

I amnot looking for an answer like: you shouldent need to.

I rather be better safe then sorry when its ugl i dont care whom its from.

what do you guys use??

I was leaning to .22 to be safer but some telling me it will take WAY too long??

ps: I have a bunch of empty steril viles and will be getting about 10 filters though will only need like 2-3 right now im hoping.
 
If I get your address I can come over and show you...:rolleyes:
 
.22
 
.22
smaller the better. if it takes a while so be it rather than have dirty oil
 
If your going to take the time to re-filter your better off using .22
 
if you trust your source then no need filtering, used many ugl without re-filtering and had good success
 
caulking gun

I have had some tell me .45 and some tell me .22.

I have a bunch of ugl gear somthing like:
50ml trenE
50ml deca
40ml test (some cyp,Eth and sust typ mix)
10ml trenA

I amnot looking for an answer like: you shouldent need to.

I rather be better safe then sorry when its ugl i dont care whom its from.

what do you guys use??

I was leaning to .22 to be safer but some telling me it will take WAY too long??

ps: I have a bunch of empty steril viles and will be getting about 10 filters though will only need like 2-3 right now im hoping.

You are going to need low viscosity oil with gorilla fingers or a caulking gun to filter through .22.
 
I bought a liter of Grape seed oil and just unscrewed the top and sucked it out with a 10ml barrel and injected it right into a few vented 50ml vials. It started as USP grade so it should be good to go.

Are you just trying to combine them or just want to filter it out of pure untrust from the source? I mean, is your shit cloudy or have crap floating in it?
 
I use .45 for oils. If you have some reason not to trust your ugl, add a ml of BA as well.
 
BA will kill bacteria, but if theres particles floating around it could case an abscess.
 
Don't forget to put 1cc of sterile oil through the filter at the end.
Make sure you get all the gear back, you may as well have 1cc of oil in the
filter than 1cc of oil @ say 300mg/cc test left in the filter.;)

I use a .45
 
Don't forget to put 1cc of sterile oil through the filter at the end.
Make sure you get all the gear back, you may as well have 1cc of oil in the
filter than 1cc of oil @ say 300mg/cc test left in the filter.;)

I use a .45

Very good point.. I generally use a .22 though, and heat the oil a bit before filtering.
 
.45.... unless you have an eternity to wait
 
.45. I had to use one because it looked like I tiny piece of stopper was in the vial after I used a big pin to speed up withdrawal.
 
Too long for your safety? Read a post once where someone showed the size of various organisms that could pass a .45

The only one I remember these days that stood out is staph, which can pass a .45.... no thanks. I'll use .22 any day
 
Too long for your safety? Read a post once where someone showed the size of various organisms that could pass a .45

The only one I remember these days that stood out is staph, which can pass a .45.... no thanks. I'll use .22 any day

Correct, bacteria are not gona make it through a .22 filter, a virus yes but no bacteria.
 
Seriously?

That was funny. You should definetly know your source well enough to have no worries. Or read up on your source. I suggest doing lots of reading and less Supps at this point. I am amzed how much information is rite here on this Board. U can get filtered needles though. and do it that way.
I wouldnt worry about it from any sponsor on this board though. You myst be getting your gear from a very unreliable to source to even ask that Question.
Please be Careful and Be patient
 

Forum statistics

Total page views
582,494,560
Threads
139,445
Messages
2,874,803
Members
161,860
Latest member
mg-roids
NapsGear
HGH Power Store email banner
yourdailyvitamins
Prowrist straps store banner
yourrawmaterials
3
raws
Syntherol Site Enhancing Oil Synthol
aqpharma
yms-GIF-210x131-Banne-B
PM-Ace-Labs-bottom
ezgif-com-resize-2-1
MA Research Chem store banner
MA Supps Store Banner
volartek
Keytech banner
thc
Godbullraw-bottom-banner
Injection Instructions for beginners
finest-gears
PCT-Banner-210x131
FLASHING-BOTTOM-BANNER-210x131
Back
Top