backfilling a slin pin

[workstoomuch]

I've been cruising this board for a while, I've found tons of good info here. So, I decided to join.

My question is about backfilling a slin pin, does anybody have any tips for doing this correctly?

I tried it a couple of times, but when I went to put the plunger back in I start to lose my IGF.

 

[Golgo13]

Whats backfilling? Do you mean, pre-loading?

 

[VanR__]

I have never mastered it.
I wish I could cuz those damn things get dull fast.

 

[Quad-smack]

Back-filling

Just leave the pinz cap on, pull out the plunger & back-fill - THEN gently put just the very tip into the barrel, tilt the syringe up to let the air buble reach the top (at the hypodermic end). Once it does, push the plunger in and let the air out. I do it all the time with Syntherol

 

[workstoomuch]

Thanks for the tip, Quad-Smack. I'll give it a try tonight.

Golgo13, Backfilling is where you pull the plunger out and load your chemical goodness of choice into the barrel, to avoid dulling the needle.

VanR, Damn do the get dull fast. When possible, stretching the skin with your free hand helped a little.

 

[Zomb131]

I did this a lot on my IGF cycle. Something I did was, pull the plunger out of the empty syringe, and slowly inject the igf info the syringe. When the small ammount of IGF trickled down to about half way down the syringe i would fill faster causing the igf make a water like bubble in the syringe. Once you got the desired amount in the syringe re-insert the plunger, and your done. Hope this helped.

 

[GoneForever]

I've done this a few times with test in a slin pin, you gotta gently just set the plunger in the hole, then when all the igf runs down to the bottom, then you can slowly push. It doesnt go in easy though. You gotta play with it a few times. With IGF I just deal with it. One stick through the IGF, one stick through bac water. Only 2 sticks doesnt dull it that bad.