Yeah, it will "crash" and youll end up with a precipitate on the bottom of the vial which is all of the drug. You will have to vent the vials then and heat them up to get it back into solution. I wouldnt want to mess with that. Like the others said, just store them in a cool dark place. Even the fridge could crash some.freeze it and it will likely fall out of solution. Not a big deal to fix but still.
It depends on how long you want to keep it. I have used 8 year old oils that sat in a closet and they seemed the same as 8 years prior. After about 8 years I put the rest of my vials in the freezer. If you keep your vials in the freezer they will likely be as potent as the day they were put in, and last until the day you die. They almost all crash and crystals come out of solution. I put a frozen vial in the microwave, set the time for 1min 20 sec and it is warm and clear. No sparking No problems at all from putting an aluminum crimp topped vial in the microwave.Im planning to stock some oils by putting them in the freezer (-18c).
What effect will this have on the effectiveness of the compound? How long past due date will the compound keeps its potency?
Do you think the micro method is any better than using an oven. I’ve always had no problem just using a hot water bath. But recently some dbol is being very stubborn. Was afraid the metal cap would be an issue. Tbh I’d rather have something crash than have excessive amounts of bb or ba to keep in suspension.It depends on how long you want to keep it. I have used 8 year old oils that sat in a closet and they seemed the same as 8 years prior. After about 8 years I put the rest of my vials in the freezer. If you keep your vials in the freezer they will likely be as potent as the day they were put in, and last until the day you die. They almost all crash and crystals come out of solution. I put a frozen vial in the microwave, set the time for 1min 20 sec and it is warm and clear. No sparking No problems at all from putting an aluminum crimp topped vial in the microwave.
I like the microwave personally. My vials have aluminum caps and no labels, so I have not had a problem with sparks or whatever. I have been putting vials in the microwave to heat up gear if crashed since 2002 and haven't had problems as long as I watched it while heating. I watch it closely and check the heat every several seconds if at room temp when starting. I swab the top with alcohol before putting it in the microwave and keep a needle ready if it isn't a fresh vial with a slight vacuum. If the stopper starts to bubble up I take it out and stab it with a needle to release pressure. Heating it up can work, I have done that with base hormones in the past when I didn't want to dilute them. Some I had to dilute anyway prior to shooting because they had too much bite otherwise. That Dbol may have some bite to it. If you have to dilute it I am fond of mct oil; it has some mild solvent like properties, holds hormone well and the low viscosity makes it easy to work with IMO.Do you think the micro method is any better than using an oven. I’ve always had no problem just using a hot water bath. But recently some dbol is being very stubborn. Was afraid the metal cap would be an issue. Tbh I’d rather have something crash than have excessive amounts of bb or ba to keep in suspension.