Safe way to transfer from bottle to vials?

[bigtig]

I have some supps that came in bottles with screw caps and while it says this is sterile I want to transfer to plugged vials.

My question its am I increasing any risk while pulling from the bottles since they are open and exposed to air? It seem like this is going to be a tricky move and I want to have all my bases covered.

Since I cant get down into the bottle I was thinking of trying to sterilize a glass to pour it in to and suck it up in to a large slip fit...

 

[kmasterflex]

just get you a filter that goes on to a syringe put the product into the syringe then attach the filter to the syringe then add a needle to the end of the filter then transfer the product into a empty sterile vial simple as that bro

 

[squids30]

I don’t care what the vial or who the sponsor is I always filter and then bake. Doing this will decreases your chances of getting an infection tremendously. It can be a pain but so can sitting in the ER with an IV of antibiotics...you pick....

 

[Dave_19]

I have some supps that came in bottles with screw caps and while it says this is sterile I want to transfer to plugged vials.

My question its am I increasing any risk while pulling from the bottles since they are open and exposed to air? It seem like this is going to be a tricky move and I want to have all my bases covered.

Since I cant get down into the bottle I was thinking of trying to sterilize a glass to pour it in to and suck it up in to a large slip fit...

You can transfer sterile gear using a 10ml/18g syringe, but this may require some extra sterilization based on your description. You can bake them at low heat around 220-250* for 20 minutes ventilated with a 23g+ pin through the rubber septum to vent pressure. You may also add .5-1% BA prior to cooking as much will cook out and help sterilize.

 

[bigtig]

Thank guys..

I will pick up a filter.

 

[biggreenstacks]

Filters

From what I've read you're going to want an extra 2ml of grapeseed oil or which ever you use, to run through the filter after you get all of your gear through it to get the last little bit out. You don't want to lose 2ml of gear.