safely reconstituting GH

[fatcat669]

hi,

this is not a math question but rather about technique. when i recon GH, i draw up 1ml bac water in a 1cc slin pin and inject it into the vial as slowly and carefully as possible and aimed at the sides of the vial. here is my problem, the bac water just SHOOTS out and rebounds off the glass and sometimes hits the GH puck... how the hell do i make it drip it slowly? no matter how lightly i press it just shoots out with severe force... its really annoying , i dont want to ruin any vials. i use the same size pin for recon as for injecting into myself, 29g 1/2" pins. should i get something bigger or????

 

[mace123]

Inject some air into the vial first.

 

[RV63T]

inlect air or pull your bw in your pin then grab the plunger at the base squeze it tight insert into vial slowly release your grip to let it in as fast as you like.

 

[The BB Monad]

That happens because of the vaccuum... Let some air in first and then inject the BW into the sides... Easy!

 

[chris250]

How much of the GH is degraded if this happens ?

 

[fatcat669]

thanks guys , injecting air made it fine

 

[Ashop]

How much of the GH is degraded if this happens ?

I doubt very little unless you spray it directly on the HGH wafer. I still think its not as fragile as some think. Care needs to be taken,,but some go to extremes.

 

[chris250]

I doubt very little unless you spray it directly on the HGH wafer. I still think its not as fragile as some think. Care needs to be taken,,but some go to extremes.

Thats kinda what I thought to...I normally just shoot the BW on the glass and it is always been fine to me...

chris

 

[longrob]

You can also try using a slin pin as a vent; just remove the plunger and put the pin in the vial. This will release the vaccuum. And leaving this vent in will also allow the BW to fit nicely into the vial.
-Rob

 

[charliel]

Seriously if u didnt know about the vacuum, you probly shouldnt be on any GH.
Thats what these boards are for so we can read and learn!!!!

 

[ludomax06]

You can also try using a slin pin as a vent; just remove the plunger and put the pin in the vial. This will release the vaccuum. And leaving this vent in will also allow the BW to fit nicely into the vial.
-Rob

yes that is what I do and it works very well.