Test suspension problem

[Meathamer]

I got some suspension and every time I load a dart and try to push it ..... It gets clogged and only half of CC goes in..... I have tried 22gauge, 21 gauge but no good..... Also I get one he'll of a lump after I get the half of CC in there....... Any clues or any help with my problem..... I know suspension can be dirty stuff but not this bad...... I've used it in past and never had these troubles...... Help a brother out if u can.....thanks in advance!'

 

[Michaelthomasj]

after shaking it...get it in the needle fast and shoot it quick. I had that problem with a certain brand years ago. It seemed to settle in the needle quickly

 

[MightyJohn]

put oil based in the same barrel & mix it......if not stacking an oil keep it moving....or plunge in & out of the vial a few times with the same size pin You are using to inject(it gives You a better suspension pull as well as breaks it down a little...if it clogs it will do the same injecting)

 

[Creed428]

i wonder if this has to do with quality at all? test suspension ive used did not do this?

 

[MightyJohn]

Has to do on weather it is"micronized" or not

 

[Stewie Griffon]

I got some suspension and every time I load a dart and try to push it ..... It gets clogged and only half of CC goes in..... I have tried 22gauge, 21 gauge but no good..... Also I get one he'll of a lump after I get the half of CC in there....... Any clues or any help with my problem..... I know suspension can be dirty stuff but not this bad...... I've used it in past and never had these troubles...... Help a brother out if u can.....thanks in advance!'

sounds like very poor quality, good suspension should go through a 25g with no problems at all. great suspension goes through a 30g slin pin

of course the gauge it can pass through doesnt tell if its legit or not, just gives a little hint

 

[done101]

agree!

 

[caveman]

I added vitamin B12 inj to the shot to dilute it. One cc of test, half a cc B12, shake the fuk out of the pin, take out air and apply!!

 

[Ulamalop]

Has to do on weather it is"micronized" or not

or emulsified with PS80

 

[FIRE0808]

Agreed with MightyJohn and Ulamalop.

 

[Tyler Durden]

I've found that the best solution is to the angle the shot so that the plunger is lower than the needle. The larger chunks will sink to the bottom and you will get the most out of the shot before it gets clogged.

 

[musclemachine]

i used to have problem with the clog.but change to oil based test sus .no more problems.

 

[Pains the game]

i used to have problem with the clog.but change to oil based test sus .no more problems.

Same here i shot a water base with a 25g and no problem but it hurt 4hrs later like hell for 3 days, then got my oil base and it was painless compared to the water base. I would suggest oil base if you want minimum pain.

 

[flex22]

next time get the ram test suspension. Mine went through a 25g with no problem and gsains were outta this world