Buy Needles And Syringes With No Prescription
M4B Store Banner
SPC-210x65
Riptropin Store banner
Generation X Bodybuilding Forum
Buy Needles And Syringes With No Prescription
Buy Needles And Syringes With No Prescription
Mysupps Store Banner
IP Gear Store Banner
Anabolic Hormones Store Banner
Ganabol Store Banner
Spend $100 and get bonus needles free at sterile syringes
Professional Muscle Store open now
LandmarkChem Email Banner
advertise1
Bruce Labs Store banner
gd
Professional Muscle Store open now
over 5000 supplements on sale at professional muscle store
granabolic123
Blackroids-animated-optimized-number-1
over 5000 supplements on sale at professional muscle store
over 5000 supplements on sale at professional muscle store
advertise1
apollo
steroidjet
kinglab
over 5000 supplements on sale at professional muscle store
over 5000 supplements on sale at professional muscle store
over 5000 supplements on sale at professional muscle store
over 5000 supplements on sale at professional muscle store
over 5000 supplements on sale at professional muscle store
over 5000 supplements on sale at professional muscle store
over 5000 supplements on sale at professional muscle store

withdrawing 10 iu's after reconstitution

5millionbucks

Member
Registered
Joined
Sep 11, 2012
Messages
230
For some reason after I reconsitute my gh I try to withdraw 10iu basically 1 ml from the syringe but there seems to be lil pockets(space from 0-10 units) basically left over solution is left in the bottle and its a pain to withdraw the rest out. Anyone know a solution to this problem, its like the syringe has a hard time withdrawing from the bottle unless I put the needle more towards the side.
 

bigtasty25

Member
Registered
Joined
Mar 28, 2008
Messages
391
Use the actual 50 unit slin syringes and I hcg twice, not the tuberculin syringe
 

880gtx

New member
Newbies
Joined
Aug 10, 2018
Messages
17
turn the bottle upside down and the syringe will get most....if you talking about the powder not mixing.....i gently roll the liquid about until it disolves....sometimes this takes up to 5 minutes.
 

sub7percent

Verified Customer
Registered
Verified Customer
Joined
Aug 16, 2015
Messages
856
There will always be some (likely immaterial) leftover amount. The more water you use the more diluted the leftover solution is and the less you lose.

All in all you probably aren’t losing as much as you think in the first place.


Sent from my iPhone using Tapatalk
 

5millionbucks

Member
Registered
Joined
Sep 11, 2012
Messages
230
yeah I do pour it upside down; then have the needle stick more on the side so I could withdraw most of the solution.
 

guest1337

Member
Registered
Joined
Mar 20, 2017
Messages
206
I flip the vial and while pulling the plunger to make vacuum to pull the gh out, I will slowly withdraw the needle while keeping pressure and as it's almost fully out of the vial it will get the last couple drops out.
 

Racepicks

Featured Member / Board Supporter / Kilo Klub
Featured Member
Kilo Klub Member
Registered
Board Supporter
Joined
Jul 31, 2010
Messages
2,968
Flip vial and pull out pin until you can barely see the tip. Slowly pull the plunger to draw as much liquid as you can. You should have half the plunger left after getting 98% of the liquid. Now slowly pull plunger while withdrawing pin, very slowly! With practice, you will draw every drop as you pull pin out of stopper.


Every little drop left in vial is a waste of money. Multiply every iu left in vial x 10 vials = equals 1 wasted vial.
 

5millionbucks

Member
Registered
Joined
Sep 11, 2012
Messages
230
Flip vial and pull out pin until you can barely see the tip. Slowly pull the plunger to draw as much liquid as you can. You should have half the plunger left after getting 98% of the liquid. Now slowly pull plunger while withdrawing pin, very slowly! With practice, you will draw every drop as you pull pin out of stopper.


Every little drop left in vial is a waste of money. Multiply every iu left in vial x 10 vials = equals 1 wasted vial.

basically what ur saying is when withdrawing the solution dont have the pin in all the way through the rubber, just a lil bit of it?
 

Staff online

Forum statistics

Total page views
509,232,774
Threads
124,934
Messages
2,416,979
Members
155,899
Latest member
Gunter.miranda
Top