I need help quick question

[soicey24]

I have some Test Enantrate and two of the vials are foggy(oil not see threw) and you can't see the sticker which is place on the vials. Which the other vial you can see threw the oil and see the sticker any suggestions on what I should do? It's a realiable source so I wouldn't think it would be a problem with the gear but I need some feedback. The lab is Gaul, so the glass is tinted.

 

[quadzilla500]

heat the oil up in some boiling water put a pin in it to vent it do not let the pin touch the oil. heat it up in some hot water. that should clear it up...

 

[SantiagoMuscle]

.

 

[strongrhino]

run vial under hot water seems as if a temperature variance has caused some seperation. that will clear it up and if not dont fool with it.

 

[soicey24]

if I put it in the oven the vial wont bust at 215F?

 

[soicey24]

I ran the water over the vial and it seem to clear up, but not as clear as the other vial. It was a big change then how it looked before I put the vial over hot water. Do you think im good to go?

 

[SantiagoMuscle]

.