hey im thinking of doing this cycle of 500mg of test enanthate ...200mg of eq for 10 weeks with a low dose dbol for first 3-4 weeks....clomid for pct...any suggestions?...plan 2 star cycle sometime in febuary..
im 24...5foot 11...210lbs...bf im estimating at 17%..been lifting since high school..have 3 cycles under my belt first one i wasted with ignorance on a dbol solo cycle had nice gains and lost pretty much all of it...diet right now im just trying to get as much carbs,protein and calories in me..eating every 3 hours...my goal is to get as much muscle mass and strength as possible maybe up weight to 225 or 230 with around the same bf% hopefully..
I would concentrate on getting nutrition dialed in and bodyfat levels at least below 12% first.
Other than that you are a tad high on test and a tad low on EQ. Look into aromasin for PCT.
i've researched and 500mg seems to be the average dose for test enanthate on cycles...i have 20 amps of test enanthate and one bottle of eq...i was thinking of a low dose eq to see how my body responds to it...how should i dose the test enanthate if 500mg is too much?...maybe do 500mg for the middle of the cycle and taper down to 250mg to finish and just lengthen the cycle to 12 weeks?...i wont be doing the cycle for a few weeks so i could get my bf% down befor i start.. cutting is no problem for me..its just bulking is harder for me...
i've researched and 500mg seems to be the average dose for test enanthate on cycles...i have 20 amps of test enanthate and one bottle of eq...i was thinking of a low dose eq to see how my body responds to it...how should i dose the test enanthate if 500mg is too much?...maybe do 500mg for the middle of the cycle and taper down to 250mg to finish and just lengthen the cycle to 12 weeks?...i wont be doing the cycle for a few weeks so i could get my bf% down befor i start.. cutting is no problem for me..its just bulking is harder for me...
Once, I transfered a bunch of amps to a sterile vile so I could run test E at 600mg per week. It was a pain, but it was a way around the problem. Overall amps are a pain IMO, viles are much easier
You can always pre-load the syringes. Like put an amp and a half in on syringe to get to whatever dose you want. it should be fine sitting in the syringe as long as you keep the environmental conditions right.