Test cyp crashed what do I do?

[Dontblink]

Was curious has any had this happen and how did you fix it?

I made some test-c at 250mg per ml used the steriod calculator and it called for 5% ba and no bb. Made it like normal and filtered with whatman .45

When it cooled it crashed so bad it looks like a solid now?

Any ideas?

 

[sluggy]

Heat it up, add some BB. Cool. Repeat if crashes again.

 

[bigpoppajr]

Heat it up in pan with hot water or...do it the lazy way, microwave it for 15-20 seconds at a time.

 

[Dontblink]

Sluggy

I made 100mls so there is some room left in the vial any idea how much bb I should add if I have 5% ba in there now?

 

[sbc5966]

Make it 5%, should work out fine.

 

[dumped2k]

just boil some water and leave it in there for 5 minutes and then shake it up...always worked for my crashed gear

 

[Rickybobby]

If its in vial stick a pin into the top air so it can breathe and heat up in water that's just below a boil that should dissolve the crashed solution

 

[Pharm_Fed]

Why is this in the article's forum?

 

[Jim550]

this shouldn't be in Articles section but anyhow if heating up doesn't work which it might not since it never kept in solution from the beginning you'll need to add more ba

 

[Performance Based]

Personally I would trash it, things don't crash if they are brewed right. I've had a ton of issues from re-making crashed gear. I honestly wouldn't use the source again.

 

[Simpllyhuge]

I've only made test E. but why is it crashing so easy.