I have a bottle of anabolic ts Test suspension, and it is impossible for me to inject it because it will not go through the needle i went as low as a 22g needle and it still won't push through!! Any help would be greatly appreciated!
Heating the bottle in boiling water before drawing into the syringe and inject immediately. It will cool down enough before injecting so don't worry about the burn form the heat, worry about the burn from the suspension! lol.
use some sterile water or bacterias static water and mix half of what you put in with the suspenion. You can also with draw some oil base stuff to lube it up inside the needle. This will enable you to plunge down with a 22 gauge.
Cheap suspension sucks-pins jam; lumps and pain at the injection site. Dont buy crap like that! Last I had a bottle of Jurox I did it for a week and threw it away. I tried every trick in the book and it was still too much trouble and pain. I did some other stuff before that was not as bad-but still pretty bad.
Non-micronized suspension is my AS pet peeve. Hate it!
Use univet or the Denkall aquatest, both microrefined @100mg/ml.
Use just a tiny bit of oil it helps alot. When I first tryed it without oil I blew up may 3 or 4 syringes in my shoulder from trying to force the shit through. Fucking suspension got all over my keyboard in my eyes and hair, LOL.
Use just a tiny bit of oil it helps alot. When I first tryed it without oil I blew up may 3 or 4 syrignes in my shoulder from tryig to force the shit through. Fuckig suspension got all over my keyboard in my eyes and hair, LOL.