Help with painful gear...Baking?

[kscowboy]

Ok i am going to use some gear i have left over from a previous cycle. Its is some prop and some npp. But when i ran it the first time it felt like i was kicked by a mule about 24 to 36 hours after i injected. The gear was potent and i liked the results but the pain the next day was horrible.

So i was reading some posts about possibly baking it to help. I cant dilute it with other oil right now so would baking it help? If so what temp and how long?

Thanks KS

 

[maldorf]

Ok i am going to use some gear i have left over from a previous cycle. Its is some prop and some npp. But when i ran it the first time it felt like i was kicked by a mule about 24 to 36 hours after i injected. The gear was potent and i liked the results but the pain the next day was horrible.

So i was reading some posts about possibly baking it to help. I cant dilute it with other oil right now so would baking it help? If so what temp and how long?

Thanks KS

From my experience, just baking what you have isnt going to do jack. Now diluting it down with sterile oil, that will work. You can also try to cut it with other AAS oil based, but that is not as effective.

 

[engbulldog]

try cuttting it with sterile cotton seed oil!!! it worked in the past when I ran some super test!!!

 

[kscowboy]

If i got some sterile cottonseed oil how do you cut it? Just pull out 1 1/2cc's of prop and then pull out 1/2cc of sterile oil....(Just as an example).

 

[gear-unit]

yeas sir thats is the way to go

 

[Stump]

If i got some sterile cottonseed oil how do you cut it? Just pull out 1 1/2cc's of prop and then pull out 1/2cc of sterile oil....(Just as an example).

Yes, that will do the trick.

 

[nickman1978]

that'll work fine...

you might want to mix it all up at once if u got an extra vial...

 

[kscowboy]

Thanks for all the help fellas. So basically just draw out some sterile oil to help dilute the gear but there is no exact ratio.

 

[Stump]

that'll work fine...

you might want to mix it all up at once if u got an extra vial...

Nick, does it total mix so that you are getting the ratio, was told never to combine in a vial due to this (don't know if this makes sense). Don't know how true also. Always did the syringe ratio so you know exactly what your getting.

 

[maldorf]

that'll work fine...

you might want to mix it all up at once if u got an extra vial...

I would get an extra vial and do this. Get a larger vial and mix the two in there and heat it in a pan of water on the stove top to make sure it mixes completely. bring the water to a small boil, keeping the level up maybe half way up the vial. Of course vent with a pin and make sure that it doesnt tip over!

Youll have to decide what end concentration you are going to be happy with. If it was really painful I would cut it down 50%. So the final concentration would probably depend on what dose you think you need to take each injection. If you can fit your dose into 3 ccs, then thats good. If the dose would be too low that you cant do it in one shot, then you might want to figure higher. So to cut it 50% roughly, youd take say 20 mls of your AAS solution and add it to the empty vial and then add 20 mls of the sterile oil.

 

[maldorf]

Nick, does it total mix so that you are getting the ratio, was told never to combine in a vial due to this (don't know if this makes sense). Don't know how true also. Always did the syringe ratio so you know exactly what your getting.

You need to heat the oil in boiling water on the stove top. then its mixed into what they call a homogeneous mixture.

 

[Stump]

You need to heat the oil in boiling water on the stove top. then its mixed into what they call a homogeneous mixture.

Thanks for explaining it a little further...was always told just to mix it in a vial.

 

[DBOYY]

i had sum test that had a mean bite and i just dilude 1/1 with gso or similar. usually just take up for example 1ml of each in srynge and heat with the hair dryer(leave an air bubble in it for expansion) while mixing back n forth. then its g2g. just my .02 goodluck brotha

 

[kscowboy]

Thanks for the help fellas!!!!

 

[maldorf]

Thanks for explaining it a little further...was always told just to mix it in a vial.

that would work ok, but I dont think it would truly be evenly mixed throughout.

 

[kscowboy]

Thanks for all the help. I just ordered some sterile oil to try to cut them with.

 

[kscowboy]

Is there any advantage of cotton seed oil vs grape seed oil?

 

[engbulldog]

no advantage that I know of,maybe cost but i havent bought any in a few yrs

 

[kscowboy]

Thanks. I ended up ordering the sterile grape seed oil. So i am just going to draw my gear into my syringe and then draw a little gso in as well. Sounds like i should be fine doing it like that.