preloading slin pins, safety?

[dale338]

I'm now taking my masteron and T using a 29 gauge 1/2" slin pin, into quads and it has been going well. But I use a 22 gauge to draw from the vile and then backfill the slin pins.

I am wanting to draw out from the vile, like two weeks at a time and then backfill the slin pins. Is this safe? So just to clarify, the oil would be preloaded into the pins for up to two weeks and stored at room temperature. Of course each pin would only be used once and the cap left on until injection time.

Thanks!

 

[Knowalink]

I find using slin pins much more a pain than just using the conventional 1” 25 gauge... quick and easy


Sent from my iPhone using Tapatalk

 

[lntense]

2 weeks is fine. Only thing you have to worry about with prolonged storage is the breaking down of the rubber stopper.


It is a little less sanitary imo, but the pros outweigh the cons for me.

 

[bullseye]

Keep an air bubble in the pre-loads and store them vertically with the point facing down. That will keep the stoppers from breaking down in the oil.

 

[manilla]

Keep an air bubble in the pre-loads and store them vertically with the point facing down. That will keep the stoppers from breaking down in the oil.

Smart guy


Also.. it’s vial OP

 

[XstarchildX]

I do this when blasting, but not during TRT or cruise.