Test 550 gelled

[jim bob]

I went to inject today after one week and found my test had gelled to the point it was just a glob in the bottom of the vial. I heated it up till the consistancy was back to normal and I injected. What caused this? It was kept at room temp. Was it ok? I hope so cause like I said I injected. This has never happened to me before on any kind of injectable. By the way this was my second vial and it did not happen on the first.

 

[jim bob]

Sorry it was test 500 not 550

 

[aw1218]

get your hands on some benzyl benzoate. add half ML, shake well and serve

 

[AMERI-Pharm]

Yeah it could be a lack of solvents. Some ug's don't like to use BB (benzyl benzoate). I would guess that was the problem. By re-heating it until it was liquid again you are set to use it. All should be good bro.

MJ

 

[Nytol]

Sounds pretty badly made, and I would bet money that it will hurt like hell.

Test is not hard to make at 500mg/ml, so should not turn into gel.

As said above, if the UG lab is skimping on slovents to save a few $, your better off not using them IMO.

 

[jim bob]

thanks for the replys. I do not have to worry about them any more because they went out of business. Acutally they still me and order :-( . But I would like to find test 500 ( 250 cyp and 250 eth) somewhere else. Because it rocks.