how much super solvent needed

[reconhardc]

to dissovle 10 grams of prop into 100mmg/ml, also what else would need to be added, I appreciate the response.

 

[weight77]

Test Prop for 10 grams

10 grams powder
72.5 ml sesame oil
5ml Benzyl AlcoholA 5%
15ml Benzyl Benzoate 15%
Syringes
Vial
Sterile Vial
Whatman sterile filter

1. Weigh out 10 grams of powder.
2. Place powder in vial.
3. Add BA & BB to the vial.
4. Heat oil in the oven to help sterilize it, heat to at least 212 degrees F. I usually heat my oil at 275 to be sure, I put the oil in a muffin pan, just fill one of the indentions this is plenty for these experiments. Also heat more oil than you need, as you will not be able to get it all out of the pan.
5. Add oil to the vial, save 2 ml of oil in the syringe for later. Gently shake vial.
6. Heat mixture if necessary. I like heating my powder products, by placing the vial in a frying pan, and placing it on the eye of the stove.
7. Place a 18 or 20 gauge needle in the sterile vial attach whatman sterile filter.
8. Place another needle in the sterile vial to relieve the pressure.
9. Draw out solution with a syringe, run though whatman filter.
10. Take other syringe with 2ml oil, run through whatman into solution.

Makes 100 ml @ 100mg/ml

 

[KaotikChem]

If you are going to use BA and BB you only need to use half that amount.

5% BA is way too high.