Have you injected the EQ by itself with any problems? Where did you inject?teedubgee said:the difference is that I shot this prop before with no problems. today I added the EQ and it burned like hell. jus wondering if I should pick a different site and try again.
thats a bit high for eq...can easily be made painless if you have any idea what you are doing. do you know how much ba/bb is in it?teedubgee said:
ask him about the ba/bb concentration because it stings. you could easily cut it with some sterile oil down to 400mg/ml and be fine.teedubgee said:a trusted source from another board
depends on how much ba is in it. if it's a good source, it shouldnt be so high it's going to cripple you. but with 500mg/ml i'd guess he put it somewhere near 5%. if this is your first injection with it...i would stop, buy some sterile oil from a supplier, along with another sealed sterile vial (because when you add the sterile oil you will probably not have enough room since this is your first eq shot from the vial...so you'll need to transfer some of it to the new vial, along ith some of the sterile oil.) if you can find out the ba/bb %'s he used for it, i will help you take down the ba% to a more tolerable level. it's very simple if you have some sterile oil and an extra vial.teedubgee said:the problem is that I don't have anything else on hand... I think it is too much ba though. Thats the second time I heard that. Can I jus finish up the pinning and deal with the burning and be fine?
Yeah, I would have suggeted just picking a different spot. The burning sensation could have been anything...........teedubgee said:nm, jus picked a different spot and it's all good! whew!!! thanks for the help though guys.