- Joined
- Feb 26, 2009
- Messages
- 238
So if you were to pin IGF-1 bi-laterally into the just worked muscle (i.e. biceps) would you use one or two pins?
I got ahold of a 19 gauge pin at my doc's office and used it to draw with for so long I can't remember, then replaced it with a smaller gauge inject pin...I kept it sterile with 90% alcohol and never had any problems whatsoever...
Exactly...when done dispose of all and never reuse.
Yup same, I always thought the one I used to draw might be dirty ( even tho I wipe the tops too) or dull. So, I just never attempted. Its worth the extra 5 cents to be safe and have a good injection IMO.
Here ya go.
Reusing that draw pins will wear your rubber stopper prematurely. Youll end up with chunks floating in your sauce is youre not careful. Just use a new fresh sharp needle each time.
sure reuse draw needle. very careful with it. it never gets touched or touches anything but the stopper. put cap back on and place open end first in the wrap the syringe came in and fold closed. reuse about 12 wks